Silicone sprays leave a smooth coat of lube over the cube's plastic to make it glide smoothly over other surfaces, thus making your cube turn smoother.
Silicon-based lubricants are a highly popular and effective way to lubricate cubes. If a cube becomes dirty or extremely gummy, it may be necessary to disassemble it and clean the pieces with soapy water and a toothbrush before attempting to relube. Experiment in a rational manner, trying to solve specific problems. There is no single agreed-on recommendation.Ī mixture of lubricants may suit your needs. The right lube depends on player and cube. For example, silicone oils tend to reduce static friction, while increasing dynamic friction.Ĭhoose the right lube, or it will make it worse. The range of lubricants available affect each of these aspects in differing degrees. Dynamic Friction - resistance felt during the turn.Static Friction - force required to initiate a turn.The following two general terms are used to characterise the friction effects of a lubricant: The most important part of speedcubing, known to halve times for many people. It is also recommended that you do not apply lube to very stiff cubes, as this can sometimes make them even harder to turn instead, try putting vaseline in the cube, then after a week or two, clean it out and then lubricate it. After lube is applied, it is usually best to not time a solve immediately, but rather give the lube a few minutes to work in.
In general, to lube a cube, you should apply the lubricant either by removing one piece and spraying it in, or by disassembling the cube completely and coating the pieces in lubricant.
This page contains descriptions of different lubricants and specific suggestions for how to use them. A lubricant (or sometimes called a lube) is a material which can be put in a puzzle to make it easier to turn or smoother, or even slower(usually used in puzzles that are too fast for someone's liking).